I've tried searching for a response to this but think that I must be missing something. I am running Landesk 9.5 and working on setting up my software distribution tasks. I would like to change the query associated with a task and seem to be unable to do so. I found a few posts for older versions of the software (http://community.landesk.com/support/thread/19744) that stated the way to remove a query is to remove the targeted devices and select "yes" to remove the associated query...I have removed all of the devices from the task but the queries were not removed. The task is currently canceled, and under all devices there are two "Unknown" devices listed. I believe these are the queries themselves as other tasks where I have only one query setup have only one "Unknown" device listed. Unfortunately whenever I try to delete "Unknown" it disappears for a brief second and then pops right back up again. Any assistance will be greatly appreciated, and if this is already mentioned in the forums somewhere I apologize for not being able to locate it.
-R